Skip to main content
U.S. flag
Back to results

Electronics Engineer

Department of the Army
Army Tank-Automotive and Armament Command (TACOM)
Directorate of Production Engineering, Process Engineering Division, 558
This job announcement has closed

Summary

About the Position: The Anniston Army Depot is located in Anniston, Alabama in the foothills of the Appalachian Mountain chain half way between Atlanta, Georgia and Birmingham, Alabama just off Interstate 20. The Depot is the largest employer in Calhoun County with Approximately 5000 employees.

Overview

Help
Job canceled
Open & closing dates
12/30/2020 to 11/03/2021
Salary
$43,366 - $100,008 per year
Pay scale & grade
GS 7 - 12
Location
1 vacancy in the following location:
Anniston Army Depot, AL
Telework eligible
No
Travel Required
Occasional travel - You may be expected to travel for this position.
Relocation expenses reimbursed
No
Appointment type
Permanent
Work schedule
Full-Time
Service
Competitive
Promotion potential
None
Job family (Series)
Supervisory status
No
Security clearance
Not Required
Drug test
No
Position sensitivity and risk
Non-sensitive (NS)/Low Risk
Trust determination process
Announcement number
SCAH20875799859D
Control number
588197100

Duties

Help
  • Obtain sufficient technical information to determine feasibility of local fabrication versus procurement of electrical/electronic instrumentation.
  • Establish and write operating, maintenance and calibration requirements and procedures for use by operator and production personnel on testing equipment.
  • Review and approve (or reject) contractor-furnished drawings for compliance with terms of the contract.
  • Make studies and investigations and proposes new or revised electrical and electronics-related systems design, design criteria, or system installation practices to improve the systems used in depot or to meet new or unusual service requirements.
  • Coordinate with the Program mangers on the identification and budgeting for equipment required to support new depot missions.

Requirements

Help

Conditions of employment

  • Appointment may be subject to a suitability or fitness determination, as determined by a completed background investigation.
  • This position may require subject to travel occasionally (up to 10%), or business and training purposes.
  • This position requires a Financial Disclosure Statement (OG-450) to be submitted.

Qualifications

Selection may be made at any grade level listed with promotion potential to the next GS-12 grade level. If selected below the full performance level, you may be noncompetitively promoted for career progression to the next higher grade level after meeting all regulatory requirements, and upon the recommendation of management.

Who May Apply: US Citizens

In order to qualify, you must meet the education and/or experience requirements described below. Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., Peace Corps, AmeriCorps) and other organizations (e.g., professional; philanthropic; religious; spiritual; community; student; social). You will receive credit for all qualifying experience, including volunteer experience. Your resume must clearly describe your relevant experience; if qualifying based on education, your transcripts will be required as part of your application. Additional information about transcripts is in this document.

Basic Requirement for Electronics Engineer:
A. Degree: Bachelor's degree (or higher degree) in engineering. To be acceptable, the program must: (1) lead to a bachelor's degree (or higher degree) in a school of engineering with at least one program accredited by the Accreditation Board for Engineering and Technology (ABET); OR (2) include differential and integral calculus and courses (more advanced than first-year physics and chemistry) in five of the following seven areas of engineering science or physics: (a) statics, dynamics; (b) strength of materials (stress-strain relationships); (c) fluid mechanics, hydraulics; (d) thermodynamics; (e) electrical fields and circuits; (f) nature and properties of materials (relating particle and aggregate structure to properties); and (g) any other comparable area of fundamental engineering science or physics, such as optics, heat transfer, soil mechanics, or electronics.
OR
B. Combination of Education and Experience: College-level education, training, and/or technical experience that furnished (1) a thorough knowledge of the physical and mathematical sciences underlying engineering, and (2) a good understanding, both theoretical and practical, of the engineering sciences and techniques and their applications to one of the branches of engineering. The adequacy of such background must be demonstrated by one of the following:
1. Professional registration or licensure - Current registration as an Engineer Intern (EI), Engineer in Training (EIT), or licensure as a Professional Engineer (PE) by any State, the District of Columbia, Guam, or Puerto Rico. Absent other means of qualifying under this standard, those applicants who achieved such registration by means other than written test (e.g., State grandfather or eminence provisions) are eligible only for positions that are within or closely related to the specialty field of their registration. For example, an applicant who attains registration through a State Board's eminence provision as a manufacturing engineer typically would be rated eligible only for manufacturing engineering positions.
2. Written Test - Evidence of having successfully passed the Fundamentals of Engineering (FE) examination, or any other written test required for professional registration, by an engineering licensure board in the various States, the District of Columbia, Guam, or Puerto Rico.
3. Specified academic courses - Successful completion of at least 60 semester hours of courses in the physical, mathematical, and engineering sciences and that included the courses specified in A above. The courses must be fully acceptable toward meeting the requirements of an engineering program.
4. Related curriculum - Successful completion of a curriculum leading to a bachelor's degree in an appropriate scientific field, e.g., engineering technology, physics, chemistry, architecture, computer science, mathematics, hydrology, or geology, may be accepted in lieu of a degree in engineering, provided the applicant has had at least 1 year of professional engineering experience acquired under professional engineering supervision and guidance. Ordinarily there should be either an established plan of intensive training to develop professional engineering competence, or several years of prior professional engineering-type experience, e.g., in interdisciplinary positions.

In addition to meeting the basic requirement above, to qualify for this position you must also meet the qualification requirements listed below:
GS-07: One year of specialized experience which includes engineering design and specifications for manufacturing, modification, calibration, and operational checkout of electrical engineering features (circuit assemblies and component parts of circuits, electronic instrumentation control systems and equipment) for combat vehicles/equipment, automated test equipment, special systems and devices, and electro-optical equipment. This definition of specialized experience is typical of work performed at the second lower grade/level position in the federal service (GS-05).
OR
Education: One full year of graduate level education in a field which demonstrates the knowledge, skills, and abilities necessary to do the work of the position, such as: Electrical Engineering.
OR
Superior Academic Achievement. In order to be creditable under this provision, Superior Academic Achievement must have been gained in a curriculum that is qualifying for the position to be filled, such as that identified in Education above. Superior Academic Achievement is based on:
(1) Class Standing - Applicants must be in the upper third of the graduating class in the college, university, or major subdivision, such as the College of Liberal Arts or the School of Business Administration, based on completed courses; OR
(2) Grade-Point Average (G.P.A.) - Applicants must have a grade-point average of either (a) 3.0 or higher out of a possible 4.0 ("B" or better) as recorded on your official transcript, or as computed based on 4 years of education, or as computed based on courses completed during the final 2 years of the curriculum; or (b) 3.5 or higher out of a possible 4.0 ("B+" or better) based on the average of the required courses completed in the major field or the required courses in the major field completed during the final 2 years of the curriculum.; OR
(3) Honor Society Membership - Applicants may be considered eligible based on membership in one of the approved national scholastic honor societies listed by the Association of College Honor Societies (https://www.achsnatl.org/).
OR
Combination of Education and Experience: A combination of education and experience may be used to qualify for this position as long as the computed percentage of the requirements is at least 100%. To compute the percentage of the requirements, divide your total months of experience by 12. Then divide the total number of completed graduate semester hours (or equivalent) by 18. Add the two percentages.

Education

GS-09: One year of specialized experience which includes engineering design and specifications for manufacturing, modification, calibration, and operational checkout of electrical engineering features (circuit assemblies and component parts of circuits, electronic instrumentation control systems and equipment) for combat vehicles/equipment, automated test equipment, special systems and devices, and electro-optical equipment. This definition of specialized experience is typical of work performed at the second lower grade/level position in the federal service (GS-07).
OR
Education: Master's or equivalent graduate degree or 2 full years of progressively higher level graduate education leading to such a degree in a field which demonstrates the knowledge, skills, and abilities necessary to do the work of the position, such as Electrical Engineering.
OR
Combination of Education and Experience: A combination of education and experience may be used to qualify for this position as long as the computed percentage of the requirements is at least 100%. To compute the percentage of the requirements, divide your total months of experience by 12. Then divide the total number of completed graduate semester hours (or equivalent) beyond the first year (total graduate semester hours minus 18) by 18. Add the two percentages.

GS-11: One year of specialized experience which includes engineering design and specifications for manufacturing, modification, calibration, and operational checkout of electrical engineering features (circuit assemblies and component parts of circuits, electronic instrumentation control systems and equipment) for combat vehicles/equipment, automated test equipment, special systems and devices, and electro-optical equipment. This definition of specialized experience is typical of work performed at the second lower grade/level position in the federal service (GS-09).
OR
Education: Ph.D. or equivalent doctoral degree or 3 full years of progressively higher level graduate education leading to such a degree in a field which demonstrates the knowledge, skills, and abilities necessary to do the work of the position, such as Electrical Engineering.
OR
Combination of Education and Experience: A combination of education and experience may be used to qualify for this position as long as the computed percentage of the requirements is at least 100%. To compute the percentage of the requirements, divide your total months of experience by 12. Then divide the total number of completed graduate semester hours (or equivalent) beyond the second year (total graduate semester hours minus 36) by 18. Add the two percentages.

GS-12: One year of specialized experience which includes engineering design and specifications for manufacturing, modification, calibration, and operational checkout of electrical engineering features (circuit assemblies and component parts of circuits, electronic instrumentation control systems and equipment) for combat vehicles/equipment, automated test equipment, special systems and devices, and electro-optical equipment.. This definition of specialized experience is typical of work performed at the next lower grade/level position in the federal service (GS-11).

Some federal jobs allow you to substitute your education for the required experience in order to qualify. For this job, you must meet the qualification requirement using experience alone--no substitution of education for experience is permitted.You will be evaluated on the basis of your level of competency in the following areas:

  • Configuration Management
  • Electronics Engineering
  • Infrastructure Design
  • Problem Solving
  • Technical Competence


FOREIGN EDUCATION: If you are using education completed in foreign colleges or universities to meet the qualification requirements, you must show the education credentials have been evaluated by a private organization that specializes in interpretation of foreign education programs and such education has been deemed equivalent to that gained in an accredited U.S. education program; or full credit has been given for the courses at a U.S. accredited college or university. For further information, visit: http://www.ed.gov/about/offices/list/ous/international/usnei/us/edlite-visitus-forrecog.html

Additional information

  • Male applicants born after December 31, 1959, must complete a Pre-Employment Certification Statement for Selective Service Registration.
  • You will be required to provide proof of U.S. Citizenship.
  • Two year probationary period may be required.
  • Direct Deposit of Pay is required.
  • This position requires you to submit a Public Financial Disclosure Report (OGE 278) or a Confidential Financial Disclosure Report (OGE450) upon entry, and annually thereafter.
  • Selection is subject to restrictions resulting from Department of Defense referral system for displaced employees.
  • This is a Career Program (CP) 18 - Engineers & Scientists position.
  • Salary includes applicable locality pay or Local Market Supplement.
  • If you are unable to apply online or need to fax a document you do not have in electronic form, view the following link for information regarding an Alternate Application.

How you will be evaluated

You will be evaluated for this job based on how well you meet the qualifications above.

Once the announcement has closed, a review of your application package (resume, supporting documents, and responses to the questionnaire) will be used to determine whether you meet the qualification requirements listed on this announcement. If you are minimally qualified, your résumé and supporting documentation will be compared against your responses to the assessment questionnaire to determine your level of experience. If, after reviewing your résumé and/or supporting documentation, a determination is made that you have inflated your qualifications and/or experience, you may lose consideration for this position. Please follow all instructions carefully when applying, errors or omissions may affect your eligibility.

You should list any relevant performance appraisals and incentive awards in your resume as that information may be taken into consideration during the selection process. If selected, you may be required to provide supporting documentation.

Basis for Rating: Qualified candidates will be assigned to one of three quality categories: Best Qualified, Highly Qualified and Qualified. Veteran preference eligibles are listed ahead of non-preference eligibles within each quality category.

  • Best Qualified. Candidates in this category possess exceptional skills and experience to exceed well above the minimum requirements for the announced position.
  • Highly Qualified. Candidates in this category possess good skills and experience above the minimum requirements for the announced position.
  • Qualified. Candidates in this category meet the minimum experience requirements for the announced position.

Army Tank-Automotive and Armament Command (TACOM)

Civilian employees serve a vital role in supporting the Army mission. They provide the skills that are not readily available in the military, but crucial to support military operations. The Army integrates the talents and skills of its military and civilian members to form a Total Army.

Agency contact information

Army Applicant Help Desk
Website
https://portal.chra.army.mil/hr_public?id=app_inq
Address
AH-APF-W0LXAA USA DEPOT ANNISTON
DO NOT MAIL
Anniston, AL 36201
US

Your session is about to expire!

Your USAJOBS session will expire due to inactivity in 8 minutes. Any unsaved data will be lost if you allow the session to expire. Click the button below to continue your session.